Product Description
Unleash the full sound capabilities in your Williams or Bally WPC95 pinball machine – rich, rumbling bass and crystal-clear vocals and sound effects – installed in 30 minutes with no permanent modifications to your game. All of our speakers and wiring kits are specifically designed by and manufactured for Flipper Fidelity to ensure 100% compatibility with the factory sound board and include our color-correct wiring harnesses to maintain a factory-original appearance. The result is a simplified, “frustration-free” installation that will add depth and detail to the sound system in your Williams or Bally pinball.
The complete three-piece replacement speaker system starts with 2 of our custom-designed, high-efficiency 5" 2-way speakers (8 Ohm speakers wired in parallel to achieve a 4 Ohm load at the amp). The capabilities of the backbox speakers are critical to delivering the majority of music, voice and sound effects in modern pinball machines while being efficient enough not to overdrive the amp at maximum volume levels. Extensive testing and design enhancements have resulted in the optimum balance of speaker performance characteristics – to bring out the best sound in your pinball machine.
To complement the backbox speaker upgrade, the kit includes our dedicated high-output 8" cabinet woofer with integrated low-pass filter with user-selectable output levels. The integrated low-pass filter rolls off frequencies above 150Hz- turning your lower cabinet into one big subwoofer. This is bass you can feel during gameplay – and is perfectly calibrated to sound-level align with our backbox speakers. This system also adds a volume attenuation control for backbox speakers. This allows for fine tuning of the relative volume between the backbox speakers and the cabinet woofer. To bring the Volume Control to the coin door you can add the Extension Harness to the system. If you prefer your backbox sound “bright and upfront” you can now order the kit WITHOUT the volume control and further simplify the installation. When you are done, it will look like it came from the factory this way!
All of our speaker kits include full-detail printed installation instructions, and you can click the link below:
FF-WB-WPC-95-8 INSTALLATION INSTRUCTIONS
We ARE pinball enthusiasts –and back everything we sell with our 100% satisfaction guarantee.
FITS THE FOLLOWING MACHINES
Attack from Mars, Cactus Canyon, Champion Pub, Congo, Junk Yard, Monster Bash, NBA Fastbreak, Scared Stiff, and Tales of the Arabian Nights
Product Videos
Custom Field
Product Reviews
2 Reviews
-
New speakers for Attack from Mars
While doing a restoration on a Bally's Attack from Mars, I decided the old speakers had to go to get an additional bump in sound quality. FF speaker kit does not disappoint. All hardware, anti-rattle tape, etc were included with easy to follow instructions. What I didn't realize was how hard it was to remove the lock "washers" holding the original 3 inch speaker panel on, but per the instructions, going slow and using good sharp wire cutters resulted in no broken plastics! Once installed, fired up the game and BOOM! Clear sound with added bass to complement this Bally Classic pin. Highly recommend the kit for anyone that takes audio seriously.
-
WILLIAMS/BALLY COMPLETE REPLACEMENT SPEAKER SYSTEM FOR WPC95 MACHINES
Overall, I'm pleased with this system. The bass response from the woofer is a nice improvement over the original cabinet speaker. The 5" panel speakers also sound better than the originals, offering improved imaging and less harshness. I wish that there was an adjustment for the frequency point of the low pass filter to further reduce some of the "boominess" but the system as-designed is already close to where I probably would set it. There was some blue tape that came with the kit that was never mentioned in the instructions. After browsing the website, it appears this must be anti-rattle tape for the playfield glass, but that's just a guess. Again, overall happy and worth the price point.
